Skip to main content
All integrations
Smart Tooling

Pick-to-Light Systems (generic) + Ignite Lean

Available now

Pick-to-light + put-to-light systems error-proof kit picks. Stream pick confirmations to builds.

REST API Webhooks

How the Connection Works

Pick-to-Light Systems (generic)
REST APIWebhooks
Ignite Lean
Into Ignite Lean
  • Pick confirmations
Back to Pick-to-Light Systems (generic)
  • Active pick sequence + light commands

How It Works

  1. 1Pick-to-light systems publish confirmations via REST / serial.
  2. 2Ignite Lean drives the active sequence and validates each pick.
  3. 3Light commands push back as part of the build.

Recommended Workflows

How Pick-to-Light Systems (generic) works best with Ignite Lean. These are recommended patterns: Ignite Lean fires the trigger, and how Pick-to-Light Systems (generic) routes it (which work group, which device, which rule) is configured to your IT setup.

Torque trace attaches to the build
Trigger An operator runs a tightening cycle
  1. 1Pick-to-Light Systems (generic) executes the tightening with the right program.
  2. 2Torque, angle, and NOK results post to Ignite Lean.
  3. 3Each fastener attaches to the build for traceability.
Full torque traceability on every unit, no paper records.
Sequence enforcement prevents skips
Trigger An operator builds a multi-fastener assembly
  1. 1Ignite Lean pushes the active sequence to Pick-to-Light Systems (generic).
  2. 2Pick-to-Light Systems (generic) only allows the next fastener in sequence.
  3. 3Skips raise NCs immediately.
Sequence violations become impossible, not just discouraged.

Connect Pick-to-Light Systems (generic) today

This works now through our REST API, outbound webhooks, and Excel/CSV. Start with the API reference, or talk to us about a guided setup.

API ReferenceTalk to Us