Skip to main content
All integrations
Smart Tooling

Avery Dennison RFID + Labels + Ignite Lean

Available now

Avery Dennison runs RFID labels at many shops. Bridge RFID to traceability.

REST API Webhooks

How the Connection Works

Avery Dennison RFID + Labels
REST APIWebhooks
Ignite Lean
Into Ignite Lean
  • RFID reads
  • Print confirmations
Back to Avery Dennison RFID + Labels
  • Print jobs

How It Works

  1. 1Avery publishes reads via REST.
  2. 2Ignite Lean attaches reads to builds for traceability.
  3. 3Print jobs push back.

Recommended Workflows

How Avery Dennison RFID + Labels works best with Ignite Lean. These are recommended patterns: Ignite Lean fires the trigger, and how Avery Dennison RFID + Labels routes it (which work group, which device, which rule) is configured to your IT setup.

Torque trace attaches to the build
Trigger An operator runs a tightening cycle
  1. 1Avery Dennison RFID + Labels executes the tightening with the right program.
  2. 2Torque, angle, and NOK results post to Ignite Lean.
  3. 3Each fastener attaches to the build for traceability.
Full torque traceability on every unit, no paper records.
Sequence enforcement prevents skips
Trigger An operator builds a multi-fastener assembly
  1. 1Ignite Lean pushes the active sequence to Avery Dennison RFID + Labels.
  2. 2Avery Dennison RFID + Labels only allows the next fastener in sequence.
  3. 3Skips raise NCs immediately.
Sequence violations become impossible, not just discouraged.

Connect Avery Dennison RFID + Labels today

This works now through our REST API, outbound webhooks, and Excel/CSV. Start with the API reference, or talk to us about a guided setup.

API ReferenceTalk to Us